Satel INTEGRA Plus Specifications download pdf (Page 7)

SATEL INTEGRA Plus 5

2.1.2 Starting the service mode "from pins"

When entering the service mode in the normal way is not possible (the control panel does not

support LCD keypads, does not accept the service code, etc.), you can use the emergency

procedure, so-called, starting "from pins."

1. Turn off the control panel power supply (first disconnect the AC power, and then the

battery).

2. Put a jumper on the RESET pins located on the control panel mainboard.

3. Turn on the control panel power supply (first connect the battery and then the AC power).

The DIALER LED will start blinking.

4. Wait a few seconds until the DIALER LED goes out and remove the jumper from the pins.

The control panel will enter the service mode. The service mode menu will be displayed

on the LCD keypad with the lowest address.

The service mode will not start if:

 the computer with running D

LOAD

X program is connected to the RS-232 port;

 the D

ISABLE

ERVICE

ODE

option is enabled – in such a case a prompt will appear

on the display, whether you want to delete all the control panel data. Pressing the

key number 1 will restore the factory settings and then will start the service mode.

The service mode can be started "from pins" even if the installer does not have access

(the administrator has disabled the P

ERMANENT SERVICE ACCESS

and has not

programmed the service access time). If this is the case, the installer can get access

to the M

ASTERS

function by entering the service code, confirmed by pressing the

key,

within about 20 seconds after ending the service mode started "from pins".

2.1.3 Hiding the service mode

The installer can hide the service mode using the H

IDE

NOW

function (SM

SETTINGS

H

IDE

NOW

). The control panel will remain in the service mode, but the service mode menu will

not be displayed. This function can be useful, if e.g. the installer has to leave the keypad, but

does not want unauthorized persons to have access in the meantime to the service menu. To

get access to the service mode menu, you must proceed in the same way as when entering

the service mode.

The service mode can be hidden automatically after a specified period of time has elapsed

since the last operation was performed on the keypad (see description of the H

IDE SERVICE

MODE AFTER

parameter p. 61).

2.1.4 Exiting the service mode

To exit the service mode you can use the S

ERVICE END

function.

After exiting the service mode, the control panel verifies whether the data in RAM memory

have changed in relation to the data stored in non-volatile FLASH memory. When the data in

RAM have been changed, a prompt will be displayed asking whether the new settings are to

be saved to FLASH memory. Pressing the key with number 1 will save a copy of the settings

to FLASH memory. By saving a copy of the settings to the FLASH memory, the control panel

will be able to restore them from a backup copy if an error is detected in the data stored in

the RAM memory.

2.1.5 Service mode menu

Service end

SM settings

Service code

INTEGRA ident.

DloadX ident.

1 2 3 4 5 6 7 8 9 10 11 12 ... 81 82

Comments to this Manuals

No comments

Satel INTEGRA Plus Specifications Page 7

Comments to this Manuals

Related products and manuals for Security access control systems Satel INTEGRA Plus