Satel INTEGRA Plus Specifications download pdf (Page 48)

46 Programming SATEL

3.3.9 Groups of partitions

You can define up to 16 partition groups which will be controlled using the 80. A

RMING

81. D

ISARMING

and 83. C

LEARING ALARM

type zones. The partition groups can be defined:

 using the keypad, in the service mode, by means of the G

ROUPS

function (Z

ONES

G

ROUPS

 using the D

LOAD

X program, in the ”Zones” window, "Arm/Disarm Groups" tab.

3.3.10 Zone testing

Using the function available in the service mode menu in the keypad (Z

ONES

T

EST

you

can test the zones. Information on violation or tamper of the zone is displayed and signaled

by beeps in keypad (violation – 5 short beeps; tamper – 1 long beep; masking – 3 long

beeps). Additionally, the function allows selection of a system output which will be used for

signaling during the test (zone violation will activate the output for 0.4 second, tamper – for

1,6 seconds, masking – for 3 seconds).

Violation/tamper/masking of the zone during the test will not trigger the response

programmed for the control panel zone.

Select a zone for testing from the list and press the or  key. The output allocated

for signaling will stop doing its present duty (if it was active, it will be disabled) until the

zone test is completed (the key pressed).

The output used for signaling is only remembered until exiting the T

EST

function. When

the T

EST

function is re-started, the output must be selected again.

If wireless sirens are used in the system and any output is selected for signaling, after

selecting a zone for testing from the list and pressing the or  key, in the wireless

sirens the signaling will be unblock (which is normally blocked for the service mode

duration).

If the output selected for signaling controls the wireless siren, it should be borne in

mind that the command to block/unblock signaling is sent out during polling. This

results in a delay whose duration depends on the programmed response period. Also

in case of the ASP-205 siren signaling is only triggered during the polling period.

4. Outputs

The system supports the following outputs:

 hardwired – on the control panel electronics board and in expanders. The number of

available hardwired outputs is determined by the control panel during identification

procedure.

 wireless – after connecting the ACU-100 or ACU-250 controller. The number of available

wireless outputs depends on the number of wireless devices registered in the system and

is determined during the procedure of adding wireless devices.

 virtual – the outputs which do not exist physically, but can be used e.g. for execution of

logical functions.

Programming of the outputs is possible:

 using the keypad, in the service mode, by means of functions available in the O

UTPUTS

submenu;

 using the D

LOAD

X program, in the "Outputs" window.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 81 82

Comments to this Manuals

No comments

Satel INTEGRA Plus Specifications Page 48

Comments to this Manuals

Related products and manuals for Security access control systems Satel INTEGRA Plus