Satel INTEGRA Plus User Manual download pdf (Page 45)

SATEL INTEGRA Plus 43

If no key is pressed on the phone for 15 seconds, the control panel will hang up.

4. Upon pressing in turn the 0 and # keys on the telephone keypad, the control panel will

hang up.

10.2 Telephone control

1. Get access to the phone call answering function (steps 1-2 in section ANSWERING PHONE

CALLS

2. Within up to 15 seconds, press in turn the 2 and # keys on the telephone keypad. 4 short

beeps and 1 long beep will confirm that you have got access to the telephone control

function.

3. Within up to 15 seconds, enter the 2-digit number of the remote switch (e.g. 01, 07 or 15).

The control panel will inform you about the switch status change by means of sounds:

3 short beeps – the switch has been turned off;

4 short and 1 long beeps – the switch has been turned on.

The operating mode of the REMOTE SWITCH type output depends on how the output has

been configured by the installer.

4. Upon pressing in turn the 0 and # keys on the telephone keypad, the control panel will

hang up. You can also press the 1 and # keys to return to the phone call answering

function.

10.3 Audio alarm verification

Remote audio alarm verification is possible when the INT-AV module is connected to

the control panel.

1. Get access to the phone call answering function (steps 1-2 in section ANSWERING PHONE

CALLS

2. Within up to 15 seconds, press in turn the 3 and # keys on the telephone keypad. 4 short

beeps and 1 long beep will confirm that you have got access to the function of audible

alarm verification. The DTMF commands you can use after starting the listen-in / talk

session are described in the INT-AV module manual.

11. Operating the alarm system by means of keyfob

In the case of a control panel to which the ACU-100, ACU-250, INT-RX or INT-RX-S module

is connected, you can control the system using the keyfob. The user can have up to 2

keyfobs:

– bidirectional APT-100 keyfob – supported by the ABAX system (ACU-100 controller

(firmware version 2.00 or newer) or ACU-250 controller);

– 433 MHz keyfob – supported by the INT-RX or INT-RX-S module.

One keyfob enables execution of up to 6 functions. For each keyfob, functions to be executed

upon pressing a button / combination of buttons, and for the APT-100 bi-directional keyfobs

also information to be displayed on the keyfob LEDs, are individually assigned (see: section

ADDING KEYFOB p. 28).

1 2 ... 40 41 42 43 44 45 46 47 48

No comments

Satel INTEGRA Plus User Manual Page 45