Satel INTEGRA Plus User Manual download pdf (Page 23)

SATEL INTEGRA Plus 21

File in DLOADX – displays the date and time of writing the data to the control panel by

means of the DLOADX program and the name of file with control panel data.

Panel version – displays information on the control panel firmware version.

STM program version – displays information on the program version of the processor

used to operate the control panel zones and power supply unit.

IP/MAC ETHM-1 – displays the IP address and MAC number of the ETHM-1 module

connected to the control panel.

Modules versions – allows to check the firmware versions for devices connected to the

control panel communication buses.

Time synchronization – allows to manually start synchronization of the control panel

clock and the time server. It applies to the control panel to which the ETHM-1 module is

connected. The address of time synchronization server must be programmed in the

control panel.

The function is unavailable, if the time synchronization is running. Automatic time

synchronization takes place every day at 05:30.

Service access – available to the master user (administrator). Allows to program the time

period of installer access to the alarm system. The time is programmed in hours.

Programming the value 0 means the installer will have no access.

Open door – allows to unlock the door controlled by the alarm system (modules executing

the access control functions) or activate the 101. CARD READ – EXPANDER type outputs.

Outputs control – allow to control the devices connected to the MONO SWITCH, BI SWITCH,

REMOTE SWITCH, SHUTTER UP and SHUTTER DOWN type outputs (see: section OUTPUTS

CONTROL

p. 34).

Service mode – available to the installer. Initiates the service mode.

Take SM over – available to the installer. If the service mode has been initiated from another

keypad, it can be "taken over", i.e. the service menu can be displayed on the keypad, on

which the TAKE SM OVER function has been started.

Downloading – the following functions are available in the submenu

Start DWNL-RS – available to the installer. Enables the control panel to be programmed

locally by means of the D

LOADX program.

Finish DWNL-RS – available to the installer. Ends the local programming of control panel.

Start DWNL-MOD. – enables remote programming through an external modem (analog,

GSM or ISDN) by means of the D

LOADX program.

Start DWNL-TEL – enables remote programming through the built-in 300 bps modem,

using the DLOADX program.

ETHM-1 – DloadX – enables remote programming through the Ethernet (TCP/IP) by

means of the DLOADX program. The ETHM-1 module with firmware version 1.03 (or

newer) must be connected to the control panel.

ETHM-1 – GuardX – enables remote operation and administration through the Ethernet

(TCP/IP) by means of the GUARDX program. The ETHM-1 module with firmware version

1.03 (or newer) must be connected to the control panel).

5.4 Arming

This section describes the operations that must be carried out by the user from the keypad in

order to initiate the arming procedure. The arming procedure is ended at the running out of

the exit delay time (if the procedure is ended successfully, the system becomes armed – see

also F

AILURE OF ARMING PROCEDURE p. 23). If the exit delay time is 0, the system becomes

armed instantly.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Comments to this Manuals

No comments

Satel INTEGRA Plus User Manual Page 23

Comments to this Manuals

Related products and manuals for Security access control systems Satel INTEGRA Plus