Satel CA-10 User Manual download pdf (Page 7)

CA-10 SATEL

LED Functions

ALARM (red color) – blinking LED indicates alarm in partition. The LED goes out

after alarm reset (when none of LEDs is blinking, the alarm cause will be shown

by the function "Viewing alarm log". The alarm may have been caused by

a zone not displayed in the partition, or the zone belonged also to another

partition, where alarm was cleared).

TROUBLE (yellow color) – blinking LED indicates there is a failure in the alarm

system. With the option „keypad trouble alarm on until cleared” (FS131) active,

it is blinking until the trouble log is viewed (key 7 function) and the function is

finished by pressing the [#] key.

1…12

1…16

- (red color) LEDs indicating the status of system zones::

 ON – zone violated,

 blinking fast – alarm memory (the zone triggered alarm, but is not

violated any more),

 ON with a short extinguishment every 2 seconds – detector tamper

(2EOL zone type),

 flashing every 2 seconds – tamper memory (detector was tampered -

2EOL zone type),

 blinking slowly – zone bypassed (indicated only with the partition

disarmed).

ARMED I, II, III, IV (yellow color) – The blinking LED indicates that partition exit

delay countdown is in process. Additionally, when the GO TO function is used,

the rapidly blinking LED indicates the partition currently controlled by the

keypad.

Note: When the function „display service message after tamper alarm” (FS131) is

active, the

[ALARM] LED, on detection of a tamper, is blinking until the

message is cleared with a service code

Functions of the LEDs change on calling the service mode or entering the user function

mode.

Some states of the control panel are additionally indicated by combinations of LEDs

[ALARM], [ARMED], [TROUBLE]:



[ALARM], [ARMED], [TROUBLE] blinking - control panel signals entering the

user function



[ALARM], [ARMED], [TROUBLE] on - control panel performs function

"Viewing alarm log"



[TROUBLE] blinking, [ALARM] and [ARMED] on - control panel performs

function "Viewing trouble log"

Additional signaling, which is only provided in the CA-10 KLED-S keypad:

 LED designated with the symbol is lit when the keypad audible alarm (buzzer)

is on.

 all LEDs blinking simultaneously (with 0,5s/0,5s timing), along with audible

signaling, informs the user that connection between the keypad and the control

panel has been lost.

 keypad illumination blinking with a high frequency - the keypad is receiving data

from the control panel.

http://www.ealarm.com.my

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Comments to this Manuals

No comments

Satel CA-10 User Manual Page 7

Comments to this Manuals

Related products and manuals for Security access control systems Satel CA-10