USER MANUAL CA-10
10
Changing display mode of system state key
Pressing and holding down the key for about 3 seconds will temporarily change the
operating mode of LCD keypad: instead of displaying text messages on the system
status it will display the state of armed zones in LCD standard (and vice versa). The
keypad will automatically return to the operating mode specified by the installer after 40
or 140 seconds since the last key was pressed (depending on how the „long backlight”
option is set).
„HOLD DOWN” User Functions
The functions are available to any user (without using the access code). They are
activated by holding down the function key for about 3 seconds.
Switching to n partition (GOTO n) [1][2][3][4]
In the alarm systems divided into several partitions (subsystems), a single keypad
control over the whole system is possible. When depressed and held down, the keys
[1], [2], [3] or [4] switch over the partition the keypad is currently controlling. The control
panel will confirm receiving the command with three short beeps and the LED indicating
the partition served will start rapidly blinking if the partition is disarmed, or will be on with
steady light, if the partition is armed. Since that moment, the panel will recognize the
keypad the function was called from, as if it was connected to the given partition.
The LED keypad enables all the operations to be performed in this partition, except for
the „HOLD DOWN” function (the GOTO function cannot be called again).
The given partition is exited automatically (the keypad returns to its own partition after
approx. 15 seconds after the last key was depressed) or after depressing the [
*
] key for
3 seconds. The panel confirms the return to its basic partition with four short and one
long beeps.
Pressing the [
*
] key in order to exit the GOTO function is immediately confirmed with
two long beeps
, and after 3-second holding down the key, return to the basic partition
ensues.
Note: If the panel does not confirm depressing the given key, it is already in its basic
partition and after three seconds it will call fire alarm from the keypad.
The LCD keypad makes it possible to switch over from one partition to another, and
then to return to the basic partition, by holding down the key with the number of next
partition (as distinct from the LED keypad, the [
*
] key does not switch over to the basic
partition). For example, when the keypad is connected to the first partition (which is its
basic partition), hold down the key [2] to switch the keypad to the second partition, then
hold down the key [3] to go to the third partition, and then hold down the key [1] to go
back to the basic partition.
Note: The above mentioned GOTO function is only available when enabled by the
installer.
Viewing alarms log [5]
By holding down the key [5] you can call the function which makes it possible to view
the alarms log.
In the LCD keypad, the following message will be displayed: „Viewing alarms log
(
)”. Pressing any key will display a date, time and source of the last alarm.
(48 pages)
(27 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals