Satel CA-10 User Manual download pdf (Page 15)

CA-10 SATEL

9 - telephone line loss - the message indicates that the telephone line is cut off. It

may also indicate lifting the receiver of a telephone connected to the

same line for longer than the time specified by the installer.

10 - problem with transmission to monitoring station – the control panel

cannot get connected to the monitoring station, or the station fails to

confirm receiving of the monitoring codes,

11 - telephone line trouble - informs that the telephone messaging has failed

(no dialing tone when the receiver is off-hook; interrupted signal instead

of continuous one; busy line).

The troubles 10 and 11 will be signaled until next successful telephone

connection. The condition can be cleared by calling the trouble check-

out function and pressing the [#] key.

12 - output 4 trouble

ALL OFF - system memory error - the message appears in case of erratic

microchip operation of the system (it may be caused by strong

electromagnetic interference e.g. produced by lightning) - in most cases

service should be called.

Pressing any key stops the function. If the installer has enabled the audible trouble

signaling, activating the trouble check-out function turns the signaling off.

Switching CHIME on/off [8]

The function makes it possible for the user to switch the chime (audible signaling of the

violation of specified detectors) on/off in the keypad. Three short beeps in the keypad

confirm switching off of the chime signaling. Four short and one long beeps

confirm

switching the chime on.

The installer decides which zones and in which keypads can use chime to signal their

status.

Keypad backlighting [9]

The function, which is only available in the CA-10 KLED-S keypads irrespective of the

installer's settings, is used to control the keypad backlighting.

After restarting the system (power-up), the keypad always enters the automatic

backlighting mode, which is activated by pressing any key. To change the backlighting

mode, press the numeric key 9 and hold it down until you hear the corresponding signal.

One beep - no backlighting.

Two beeps - automatic backlighting.

Three beeps - continuous backlighting.

Fire alarm [

]

This function activates the fire alarm from the keypad.

Auxiliary alarm [0]

The purpose of this alarm depends on current needs. It may be, for instance, an

emergency call for medical assistance. The function may transmit an appropriate

message about auxiliary alarm to the monitoring station and activate telephone

messaging.

http://www.ealarm.com.my

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments

Satel CA-10 User Manual Page 15

Comments to this Manuals

Related products and manuals for Security access control systems Satel CA-10