Satel INTEGRA User Manual download pdf (Page 46)

User Manual INTEGRA 44

View cleared alarms

The function is available, provided that the user has not viewed the violated zones. It makes

it possible to check which zones triggered the alarm. After completion of the viewing, the

function will be unavailable.

System reset

The function is available to the installer (service), if the option REQUIRED SYSTEM RESET AFTER

VERIFIED ALARM

is enabled, and a verified alarm took place. After occurrence of the verified

alarm, it is necessary to reset the system by means of this function, in order to make re-

arming possible.

Disarm

The function allows disarming of one or several selected partitions, or all partitions accessible

to the user, from the given keypad.

Clear alarm

The function clears alarm signaling in system.

Clear other alarms

The function makes it possible to cancel alarms from other objects, to which the user has

normally no access.

Abort voice messaging

When this function is called, the telephone messaging is stopped – the control panel should

ring off. If the telephone line is still occupied, there must be messaging in the process from a

partition non-accessible to the given user.

The messaging by telephone may be cancelled automatically together with an alarm clearing

PROG.

Note: If the installer fails to assign the selected telephone number to a partition the users of

which are authorized to cancel the voice messaging, the procedure of voice

messaging will run to the end, without any possibility to stop it.

Arm

The function allows arming of one or several selected partitions, or all partitions accessible to

the user.

Arm (2 codes)

The function is available when at least one partition in the system requires entering two

codes to be armed. After starting the function, select the partition(s) to be armed (

- partition

selected; - partition not selected) and confirm using the [#] key. Depending on how the

partition has been configured by the installer, it may also be necessary to determine the code

validity period. If the code validity time is not programmed by the user, it will be 60 seconds.

The first code can be optionally cancelled (see the CANCEL 1ST CODE function).

The partition will be armed after the second code is entered (in case of the LCD keypad, the

user using the second code must run the ARM function, and in case of the partition keypad –

enter the code and confirm with [#]). During the first code validity period, the and

LEDs are alternately blinking in the partition keypads.

The installer can configure the partition so that the second code must be entered from

a different keypad than the first code.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 74 75

Comments to this Manuals

No comments

Satel INTEGRA User Manual Page 46

Comments to this Manuals