Satel INTEGRA User Manual download pdf (Page 39)

INTEGRA SATEL

Note: The special armed modes, as described earlier, are also defined for timers.

• partition arming control by means of a special zone programmed (by the installer) as

arming control zone. In practice, it may be a mechanical switch; key switch, pushbutton,

radio switch. It is also possible to control such a zone by means of the REMOTE SWITCH

type output (see: ANSWERING PHONE CALL). Disarming by means of the zone can also clear

the alarm and telephone messaging;

Note: The zone will arm always, unless the option CHECK ARM POSSIBILITY is enabled. If this is

the case, all the conditions which make arming impossible (see page 34) will be taken

into consideration.

• arming/disarming by the use of code and arrow keys (see: USE OF LCD KEYPAD) – this

mode facilitates access to the above mentioned "special ways of arming".

6.11 ALARMS

The system may signal alarms as the response to various situations that occurred in the

protected facility. The basic control panel alarms include:

Burglary alarm – activated when the zone is violated in the partition where arming is on.

Violation of the “delayed zone" starts countdown of the delay time, after expiry of which

an alarm is activated unless the partition is disarmed.

Fire alarm – activated by fire detectors, from keypad or otherwise (e.g., by pressing

pushbutton).

Tamper alarm – activated by violation of any tamper contacts in the alarm system (located in

detector and module casings), damage to cables, etc.

Panic alarm – activated from keypad or otherwise as defined by the installer (e.g., by

pressing pushbutton).

Auxiliary alarm – activated from keypad (for example, call for medical aid) or otherwise as

defined by the installer (e.g., remote controller or pushbutton).

Technical alarm – activated by various specialist detectors.

The way of signaling individual alarms may be different, as defined by the system installer. It

may be an alarm siren, information to the monitoring station, visual alarm, audible alarm

and/or keypad message, telephone message, activation of other external devices.

The alarm can be cleared by a user authorized to clear alarms in the given partition/object.

The alarm will be cleared after entering the code and confirming it with the [#] key. If the user

is authorized to disarm the partition, the alarm clearance will be accompanied by disarming.

The disarming will not be effected automatically, if the user may disarm more than one

partition. He must then chose the partitions to be disarmed. He can also cancel the disarming

by pressing the [

] key. In order to clear the alarm without disarming the partition, it is

possible to use the user function CLEAR ALARM.

Immediately after the alarm is cleared, viewing of the violated zones is possible. If the user

decides not to view them immediately, he can do it at a later date by means of the user

option VIEW CLEARED ALARMS. The function will be available in the user menu until the viewing

is done.

6.12 ALARM MESSAGING BY TELEPHONE

All the INTEGRA series control panels can inform about events in the system by means of

voice messages (connection of voice synthesizer is required), as well as PAGER type text

messages. The INTEGRA 128-WRL control panel can additionally notify by means of SMS

type messages. The SATEL made GSM modules offer the feature of converting the PAGER

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 74 75

Comments to this Manuals

No comments

Satel INTEGRA User Manual Page 39

Comments to this Manuals