Satel INTEGRA User Manual download pdf (Page 38)

User Manual INTEGRA 36

2. Call the ARMING MODE function.

3. Using the S and T keys select one of the suggested arming modes and press [#].

4. Call the ARM function and select (highlight) the partition to be armed.

5. Press the [#] key.

In order to re-enable the special armed mode, the above procedure must be repeated.

If the function of quick arming without code entry has been made available by the service in

LCD keypad /partition keypad, you can enable the special armed mode by successively

pressing the keys:

[1] and [#] – full arm with bypass;

[2] and [#] – armed without interior;

[3] and [#] – armed without interior and without entry delay.

The procedure of arming the system from a LCD keypad in the partition to which the type

(10) 24H VIBRATION zone belongs and the testing function of vibration sensors is activated

PROG is somewhat different.

When the arming function is called, the following message appears on the LCD display:

"Vibr. zone test xx s (1=arm)" where the xx field indicates the number of seconds before the

end of test.

During the test, the control panel is waiting for the violation of vibration zones in a given

partition. If all the vibration zones of the given zone are violated, the alarm control panel will

proceed to counting the exit delay time and arming the system. If any of the vibration zones is

not violated during this time, the control panel will display a list of faulty zones (number and

name of zone) and will not arm the system.

Pressing the digit 1 key during the process of countdown will interrupt the test and arm the

system in normal mode, while pressing the [

] key will make it possible to cancel the arming.

Arming the system from the partition keypad will bypass the testing of vibration sensors in the

particular partition.

The user can disarm the system using one of the following ways:

• entering [CODE][#] in LCD keypad – all partitions or some selected partitions only can

be disarmed;

• entering [CODE][

] or [CODE][#] in partition keypad – the partition to which the keypad

is assigned can be disarmed;

• entering [CODE][

] in LCD keypad and choosing D

ISARM function – selected partitions

can be disarmed;

• bringing the card closer to the INT-CR proximity card arm/disarm device and

moving it away after approx. 0.5 second – all partitions operated by the module will be

disarmed;

• bringing closer or holding card in the proximity of the reader (depending on

expander settings) – the partition to which the reader is assigned will be disarmed;

• bringing closer or holding DALLAS chip in the reader (depending on expander

settings) – the partition to which the reader is assigned will be disarmed.

Also, special control ways of partition status are possible:

• partition arming and disarming by means of timers. The timer is an internal control panel

logic unit which measures time. Timer operation is programmed by the service;

• partition arming and disarming by the “partition user timer". Operation of this timer may be

programmed by the partition user, without having the installer (or the service) to do the job.

There is a single partition timer of this type, which can be programmed in daily or weekly

cycle (see: D

ESCRIPTION OF USER FUNCTIONS ÆCHANGE OPTIONS);

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 74 75

Comments to this Manuals

No comments

Satel INTEGRA User Manual Page 38

Comments to this Manuals