Satel INTEGRA Specifications download pdf (Page 29)

SATEL Installer Manual 27

2. The control panel program checks the control panel data saved in the RAM memory

(the memory has a battery backup). If no error is detected, the control panel will be started

with current settings.

If an error is detected in the data saved in RAM memory, the settings will be restored from

FLASH memory. A copy of the settings is stored in the FLASH memory. A prompt about

saving the copy of settings to FLASH memory is displayed on the LCD keypad when

exiting the service mode in case the current settings are changed. In the DLOADX program,

you can use the

icon to save a copy of settings to FLASH memory. Saving the data to

FLASH memory is followed by a restart of the control panel.

The control panel with factory settings (new one or one after restart of settings) supports all

keypads connected to the bus. It does not, however, control the status of keypad zones and

tamper contacts, and does not provide for programming the security system parameters.

Prior to programming the system, you should:

1. Set individual, correct addresses in keypads.

2. Start the keypad identification function (SERVICE MODE ÆSTRUCTURE ÆHARDWARE

ÆIDENTIFICATION ÆKEYPAD IDENT.).

3. Start the expander identification function (SERVICE MODE ÆSTRUCTURE ÆHARDWARE

ÆIDENTIFICATION ÆEXPAND IDENT.).

3.13 STARTING GSM TELEPHONE

Due to the specific character of data transmission using GPRS technology and

possible costs involved, it is advisable to install in the control panel a SIM card

with tariff plan providing for at least 10 MB monthly data transfer.

Fig. 24. Inserting SIM card into its socket.

The GSM telephone can only be turned on after the control panel has been started. Antenna

must be connected to the corresponding socket in the control panel (see: Fig. 2). There must

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Satel INTEGRA Specifications Page 29