Satel INTEGRA Specifications download pdf (Page 17)

SATEL Installer Manual 15

2. Start the function KEYPAD ADDRESSES (ÆSTRUCTURE ÆHARDWARE ÆIDENTIFICATION

ÆKEYPAD ADDRESSES).

3. The message shown in Figure 7 will appear on display of all keypads connected to

the control panel.

Fig. 7. Programming keypad address by means of service function.

4. Enter a proper address from the 0–7 range in the selected keypad(s). The address

change will be confirmed by four short and one long beeps.

5. To terminate the address change function, press the [

] key. The function will be

terminated automatically after 2 minutes from being started. Termination of the

function will restart the keypad (return to the main service mode menu will follow in

the keypad from which the function has been started).

3.5.1.2 Programming keypad address without entering service mode

This method of address programming is particularly useful when – due to repeating

addresses – the keypad support has been disabled and entering the service mode is

impossible.

1. Disconnect keypad power supply (KPD) and signal wires CKM and DTM.

2. Short the keypad terminals CKM and DTM.

3. Switch on keypad power supply.

4. The text shown in Fig. 8 will appear on the display.

Fig. 8. Programming keypad address without entering the service mode.

5. Enter a new address from the 0–7 range. The keypad will confirm execution of the

function by four short and one long beeps. If it is necessary to change the entered

address, press the [

] key (keypad restart will follow and the text shown in Fig. 8 will

again be displayed).

6. Disconnect the keypad power supply.

7. Open the keypad terminals CKM and DTM.

8. Connect the keypad correctly to the control panel.

3.5.2 Numeration of keypad zones

The address set in the keypad defines which numbers in the system will be assigned to the

keypad zones (see: Table 2). You can define for each LCD keypad whether or not its zones

will be used in the system. If the zone numbers of LCD keypad and expander coincide, the

keypad zones have priority (in such a case, the corresponding expander zones will not be

supported).

n=0...7, current address of the

keypad

n=0...7, current address of the

keypad

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

No comments

Satel INTEGRA Specifications Page 17